Customized Seat Covers Installation Tutorial

Front Seat Backrest Cover Installation


1.Unzip the back and pull the cover straight down over the seat. Ensure it fits snugly around the shoulders.

2.Align and press the headrest holes into the plastic trim gap.

3.Insert the three anti-slip tabs between the seat back and base. From the back seat, pull them through, fold upward, and secure with the hook-and-loop fasteners.

Tip:
Refer to the diagram when installing the seat bottom to avoid wrinkles.

Rear Seat Bottom Cover Installation


Align the cover with the seat edges and belt buckles. Push the straps through the gap between backrest and seat base, then tighten.

Fasten and adjust the front and rear straps under the seat.

Tip:
Follow the diagram to ensure a smooth, wrinkle-free fit.

Steering Wheel Cover Installation Tutorial

1. Start at the Top
Place the cover over the top of the steering wheel and press it into place.

2. Work Down the Sides
Pull the cover tightly down both sides of the wheel.

3. Finish at the Bottom
Stretch the cover over the bottom and adjust for a snug fit.

4. Final Adjustments
Make sure the cover is centered and smooth all around.

Tip:
Use a hair dryer to warm the cover before installing. Heating makes it more flexible and helps reduce creases.

Center Console Cover Installation Tutorial

1. Open the Center Console
Lift the lid of the armrest.

2. Slide On the Cover
Stretch the elastic band around the lid.

3. Adjust for Fit
Center the cover and adjust left or right until it fits snugly.